Ready-made cable set for the additional headlights from LAZER with ready-made waterproof plugs for two headlights, fuse, 12V relay and switch for the vehicle interior. Four connections are required to establish the electrical connection:
• +12V (battery): The power supply is connected to the starter battery via a ring terminal lug. The supply line (red) is protected against overload by a fuse
• Ground: The ground cable (black) is connected to a suitable ground point via a ring terminal lug.
• Signal:
•Vehicles with halogen headlights: With halogen headlights, the control voltage for switching the relay is taken from the power supply of the main-beam headlights. To do this, the cable is cut open and connected to the control line (purple) using a solder connector. The solder connector is included in the scope of delivery.
•Vehicles with LED main headlights: If no 12V high beam signal can be tapped, the signal must be tapped from the CAN bus. You will also need a CAN bus interface for this
•Headlights: The headlights themselves are pre-wired and are connected to the cable set using waterproof plug connectors.
Technical data:
•Length of cable to the spotlights: 1.20 m
•Fuse protection: 30A Installation should be carried out by a workshop with specialist knowledge of vehicle electrics.
